Evap problem - Maintenance Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
Evap problem
Saturday, May 19, 2007 2:01 PM
hey what's up , just had a check engine light light come up a couple weeks ago for a evap emission problem, just wondering if anybody has had this problem and what the most likely cause would be, as I dont own a scanner or a multimeter at this moment. Just wondering if the air purge solenoid went bad or if the code means there may be a leak in the system. any replys appreciated thanks




Alex
02 red chevy cavalier ls sport

Re: Evap problem
Saturday, May 19, 2007 9:12 PM
it happened to me to , but it was that i did not screw on right the gas cap
Re: Evap problem
Sunday, May 20, 2007 6:46 PM
i tested my gas cap its not bad, funny though
Re: Evap problem
Monday, May 21, 2007 12:01 PM
what code was it??

even if the gas cap tested good EVAP tests take a long time to run and therefore dont clear right away.


ASE Master Auto Technician & Advanced Engine Performance Specialist
GM Mark Of Excellence Platinum Award (Engine repair)
GM Corvette Technician requirements complete
Re: Evap problem
Tuesday, May 22, 2007 7:52 AM
um the code was p0440 it just said a general evap problem, i know it takes a long time to run the test, just didnt know if it means a leak in the system? any help much appreciated thanks

future gm tech hopefully
Re: Evap problem
Tuesday, May 22, 2007 1:04 PM
p0440 is the code for a gross(large) EVAP leak. usually means a gas cap, but it could also be a leaking tank, leaking purge or vent lines, a vent solenoid that wont close or a bad fuel tank pressure sensor.


ASE Master Auto Technician & Advanced Engine Performance Specialist
GM Mark Of Excellence Platinum Award (Engine repair)
GM Corvette Technician requirements complete
Re: Evap problem
Wednesday, May 23, 2007 7:11 AM
alright well i guess im just gonna to have to use the smoke machine or somethin and hopefully i find the leak or ill just replace the vent solenoid, i hooked up a scanner and tryed to operate the purge solenoid and could not hear anything so hopefully it is that and replacing will fix it, thanks for all the help


Alex
student at unoh
Re: Evap problem
Wednesday, May 23, 2007 1:46 PM
check closely around the fuel pump seal
Re: Evap problem
Tuesday, May 29, 2007 8:12 PM
I have not yet found a charcoal canister on my car yet so i belive it must be a bad seal on your fuel cap. The Locking replacement ones suck! I would also inspect the area around your fuel tank for a cracked evap line and stuff like that.
Re: Evap problem
Monday, June 04, 2007 11:59 AM
The EVAP charcoal canister is under the car in the space between the axle and fuel tank, right near the fuel filter.


ASE Master Auto Technician & Advanced Engine Performance Specialist
GM Mark Of Excellence Platinum Award (Engine repair)
GM Corvette Technician requirements complete
Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search